QuickLock Flex Sleeve

QuickLock Flex Sleeve

The QuickLock Flex Sleeve is a no-dig point repair system for repairing joint offsets or axial bending inside the pipe. The sleeve features a corrugated steel core with two short 316L QuickLock sleeves on either end with the trademark locking mechanism. The entire sleeve is encased in an EPDM rubber gasket to create a seal against the inside pipe wall.

Application for:

  • Correcting joint offsets up to 1" (2.5cm)
  • Correcting axial bending

The QuickLock Flex sleeve is available in nominal diamters of 8" to 24" and in the following lengths: 14" (8" - 16" diameter) & 18" (18" - 24" diameter).

QuickLock Flex on Packer

Operating Principle:

The sleeve body is of 316L stainless steel with a flexible corrugated steel core, covered by an EPDM rubber gasket designed to seal against the pipe wall. The system works strictly on mechanical compression - no resin or grout is involved. The sleeve is expanded by a specially designed packer and locks into place by the one-way ratchet locking gear mechanism.

Advantages of QuickLock Flex:

  • The Flex can seal the offset joint with a secure connection on both sides of the joint.
  • The Flex can repair offset joints without milling or other prep work.
  • The corrugated steel core provides a continous protection of the EPDM seal.
  • Passes air & water pressure testing.
  • Reinstates structural strength & integrity of deformed and damaged pipe.
  • Can be installed with flow present.
  • Easy and quick installation - no cure time.
QuickLock Flex Variety